Before screwing on the panels, I made
some channels for the wiring by grinding some slots in the vertical
pieces. When the panels are in place, the wires will be neatly behind
them.
|
|
|
I then laid out for some
screw holes and drilled two of the holes to mount one panel before
drilling anymore. After the panel was secured with two screws, I
then drilled the rest of them. This way I was sure that all the holes
would line-up. I over-lapped the two pieces by two inches instead of
butting them up against each other like I originally planed. I used
three screws in the larger areas and two screws on each end. At this
point, the firewall is finished but I'll still have to remove it when I
revisit the roll cage as the down-bars will be passing through it.
|
|
|
|
1
2
3 4
5 6
7 8
9 10
11 12
13 14
15 16
17 18
19 20
21 22
23 24
25 26
27 28 |
|
29 30
31 32
33 34
35 36
37 38
39 40
41
Main 33
Coupe Page |
