Now because there's no more real-estate
left under the dash, I made some brackets to hang my new components. I
ended up making four of these little L shaped brackets.
|
|
|
Here you can see the relay and receiver
attached to there new brackets. I mounted them as high as I could next
to the top of the dash. I bought some five and six wire connecters that
will be replacing the crimp on ones that you see.
|
|
|
This is one of the actuator that was
part of the keyless entry kit. This mounts to the door with three
screws. The small rod with the "J" shaped end goes through the
eye of the actuator and the other end connects to the door
linkage with the small silver adapter. You can have this either
"pull" or "push" depending on your application. I'm
going to use the "push" mode in my car which means using the
blue wire for 12 volts. By using the 12 volts on the green wire, it
would then "pull". The other wire that you don't have 12 volts
to just has to go to ground and that's it which makes it very simple to
hook-up.
|
|
|
I removed the door panel so I could
find a place to mount the actuator. I found a place at the bottom left
corner that should work fine. There's not much room to work inside of
car doors and these were no exception.
|
|
|
|
1 2
3 4
5 6
7 8
9 10
11 12
13 14
15 16
17 18
19 20
21
22
23 24
25 26
27 28 |
|
29 30 31
32 33
34 35 |
