33 Coupe Fuel System 15        12/26/03

Here you can see the vent line clamped to my new piece. This won't be visible after the floor is in so the if things look a little crude, this is why.
 

 

 
And a shot from under the car. This looks much better than if a piece of hose were sticking out. The nut that you see next to the vent is one of the three rear bolts holding down the floor of the trunk. 
 

 

 

I notched the floor out for the line to fit through. This makes it easy to work on and get at if need be. The wires for the sending unit will pass through here too.
 

 

 
At this point, the fuel system is almost complete and you can see what it looks with the vent tube is in place along with the wires for the sending unit. The last thing I have to do to the fuel system is work on the fuel pressure gage and isolator. After that, the fuel system will be done. The wiring for the rear of the car along with the fuel pump runs along the frame rail like the fuel line does and then up through a hole in the floor of the trunk. The wires that come through the trunk are for the tail lights, brake lights, fuel sending unit, ground and a few that will be going to the interior.  While we're on the subject of wires, lets go back and finish the battery box installation. 
 

 

1  2  3  4  5  6  7  8  9  10  11  12  13  14  15  16  17  18  19